previous
  • 7 Solutions for Kitchen Layout and Design
    7 Solutions for Kitchen Layout and Design
  • Top 10 Videos of 2011
    Top 10 Videos of 2011
  • Replacing a Roof : Installing a Ridge Vent
    Replacing a Roof : Installing a Ridge Vent
  • Larry Haun: One Carpenter's Life (1931-2011)
    Larry Haun: One Carpenter's Life (1931-2011)
  • 10 Basement-Remodeling Tips and Techniques
    10 Basement-Remodeling Tips and Techniques
  • Your Guide to Energy Smart Homes
    Your Guide to Energy Smart Homes
  • How to Avoid Complicated Fractions
    How to Avoid Complicated Fractions
  • See the Latest 2013 Houses Awards Entries
    See the Latest 2013 Houses Awards Entries
  • Buyer's Guide to Insulation
    Buyer's Guide to Insulation
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Tool Test Preview: Compact Compressors
    Tool Test Preview: Compact Compressors
  • Roofing articles, videos, tools, and materials
    Roofing articles, videos, tools, and materials
  • The Inspector Game: Goofs on a Roof
    The Inspector Game: Goofs on a Roof
  • Fine Homebuilding: The Digital Issues
    Fine Homebuilding: The Digital Issues
  • An Introduction to Thermal Imaging
    An Introduction to Thermal Imaging
next


Craftsman Room Addition phase 5

comments (0) December 4th, 2008 in Project Gallery        
Huck Huck, member
1 user recommends

The fascia at the end of the addition is not square - it is angled like the prow of a ship. 
The utilities are added at this stage: plumbing, electrical, cable, and hvac.  Here you see insulated ductwork being run for the heating and cooling.
You can also see in this picture the radient barrier foil on the bottom of the roof sheathing.
This is a view looking up at the patio ceiling.  You can see Ive run a purlin under the rafters, with vertical kickers down to the bearing wall.
This might be overkill, but the architect put that huge ridge beam in, without a lot of thought to how it would be supported.  Ill have more on that coming up - but by adding this purlin Im sharing some of the load the ridge beam would have taken.
We finally removed the exterior wall, opening the house up to the addition.  Now you can see how the addition is just half of the room, which will be one big room.
This overview from the backyard lets you see the addition in perspective to the rest of the house.
The fascia at the end of the addition is not square - it is angled like the prow of a ship. Click To Enlarge

The fascia at the end of the addition is not square - it is angled like the prow of a ship. 


Once the roof was sheathed there was still a lot to do.  There was some "pickup" framing (meaning loose ends that needed to be tied up), and the utilities had to be roughed-in.  We finally got permission to remove the exterior stucco wall that was separating our addition from the rest of the room it would be joining.

 Please note: I am the General Contractor, not the designer of this project.


Design or Plan used: My own design - HP Construction
posted in: Project Gallery

Comments (0)

You must be logged in to post comments. Click here to login.