October 22, 2009
If you've lost the cap for the nipple on your pneumatic nailer, but want to keep the dust from building up and clogging the air line, try this simple tip.
October 11, 2009
This zero-clearance circular-saw base ensures the edges of your plywood cuts stay clean
October 8, 2009
This smart solution for holding down lumber with a make-shift bench is sturdy and cheap
September 16, 2009
If you need a number of studs or deck boards cut to the same length, this accurate, time saving trick is your solution
September 10, 2009
A simple and effective way of patching small holes in drywall or plaster is done without tape.
August 26, 2009
Does throwing away an old, clogged caulk tube pain you? At five to ten bucks a pop it could. Here’s a way to revive old caulk tubs and even improve…
July 16, 2009
With this device, I am able to check my coping without climbing a ladder, and if it is not a good fit, I am able to see exactly where and…
July 15, 2009
This simple setup uses a couple of sawhorses, some long screws, and a few pieces of plywood to make a spinner for supporting a door while it is painted.
June 8, 2009
When it comes to drywall, knowledge is power. Check out these variations on patching walls.
May 26, 2009
Two easy ways to make crown molding installation go smoother
Subscribe to Fine Homebuilding magazine now and save up to 52%
© 2017 The Taunton Press, Inc. All rights reserved.
Become a member and get instant access to thousands of videos, how-tos, tool reviews, and design features.
Start your subscription today and save up to 52%