previous
  • 12 Remodeling Secrets
    12 Remodeling Secrets
  • Remodeling in Action
    Remodeling in Action
  • Shorten a Prehung Door
    Shorten a Prehung Door
  • Magazine Departments
    Magazine Departments
  • Buyer's Guide to Insulation
    Buyer's Guide to Insulation
  • The Passive House Build
    The Passive House Build
  • Electrical Articles & Videos
    Electrical Articles & Videos
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • All about Roofing
    All about Roofing
  • How to Install Housewrap Solo
    How to Install Housewrap Solo
  • Deck Design & Construction
    Deck Design & Construction
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • The Hobbit House and More
    The Hobbit House and More
  • Video: Build a curved step
    Video: Build a curved step
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Play the Inspector Game!
    Play the Inspector Game!
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Energy-Smart Details
    Energy-Smart Details
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Master Carpenter Videos
    Master Carpenter Videos
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
next
Pin It

Home Energy Diet for an Old Victorian

Sealing the crawlspace and plugging holes cut a big home's heating bill in half

Even though the task might seem insurmountable, it's possible to rein in the energy losses of an old, leaky house. It just takes a lot of hard work, as contractor Jeff Tooley demonstrates in this project. This 2800-sq.-ft. Victorian was uncomfortably cold every winter, and to make it more energy smart, Tooley and his crew worked from the bottom up. They began their work by sealing the crawlspace with a variety of products, including polyethylene sheeting, polyisocyanurate insulation, reinforced poly vapor retarder, and caulk. After the crawlspace was finished, they began sealing framing cavities, using three techniques: plugging the cavities with rigid foam held in place with spray foam; sealing the kneewall floor with flexible foam; and filling the joist cavity with spray foam. Finally, they added attic insulation, including spray foam and loose-fill cellulose. They also had an HVAC contractor install a fresh-air supply to the mechanicals room. Where necessary, Tooley and his crew cut access holes as part of their retrofit work. 

Home Energy Diet for an Old Victorian

Become a Fine Homebuilding Member

to view this article and over a thousand more

Learn More