previous
  • Remodeling Articles
    Remodeling Articles
  • Radiant Heat Comparison
    Radiant Heat Comparison
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Design Inspiration
    Design Inspiration
  • Video: Install a Fence
    Video: Install a Fence
  • Master Carpenter Videos
    Master Carpenter Videos
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Ultimate Deck Build 2015
    Ultimate Deck Build 2015
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Vormax Toilet Sweepstakes
    Vormax Toilet Sweepstakes
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
  • All about Roofing
    All about Roofing
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Magazine Departments
    Magazine Departments
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Install an Outlet Box
    Install an Outlet Box
  • Video Series: Tile a Bathroom
    Video Series: Tile a Bathroom
  • Energy-Smart Details
    Energy-Smart Details
next
Pin It

Retrofitting French Doors

Open up the wall to a great view. The tricks: Adjusting the fit and hardware.

When installing a new door in an old wall, it's rare for that wall to be perfectly plumb, level, and square. In this article, remodeling contractor Mike Sloggatt provides a detailed account of the steps he took to install new French patio doors in Fine Homebuilding's Project House. He begins by discussing the three options for installing a door in an out-of-plumb wall. The first is to hang it to match the wall. This is a viable method if the distance the wall is out of plumb is 3/8 in. or less over 8 ft.; otherwise, the door may develop phantom swing, which is when the door swings open or shut on its own. The second option is to hang the door plumb, which will work if the door is within 1/4 in. of plumb but will present problems for trim and siding if it's greater than that. The third option is to hang the door almost plumb--essentially a combination of the first two options. This is the method Sloggatt chose for the doors at the Project House. First, he prepped the opening, which involved checking it for plumb, level, and square and then using a sledgehammer to bring the wall closer to plumb. Second, he installed the pan after applying flexible flashing, then set the door in place. The final steps were positioning the door, checking the diagonals, fastening the door, strengthening the hinges, and installing the hardware. Sloggatt recommends two tools for installing doors, both of which he used on this project: an 8-in. suction cup for help in lifting doors, and a Pump Wedge, which holds a door in place with an adjustable amount of friction.

Retrofitting French Doors
Plus get a free gift
Become a Fine Homebuilding Member. Start your free trial now