previous
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • Video: Install a Fence
    Video: Install a Fence
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Master Carpenter Videos
    Master Carpenter Videos
  • 12 Remodeling Secrets
    12 Remodeling Secrets
  • Slideshow: 12 Stunning Remodels
    Slideshow: 12 Stunning Remodels
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Energy-Smart Details
    Energy-Smart Details
  • Remodeling in Action
    Remodeling in Action
  • Design Inspiration
    Design Inspiration
  • All about Roofing
    All about Roofing
  • Magazine Departments
    Magazine Departments
  • Solid Deck-Framing Advice
    Solid Deck-Framing Advice
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Gallery: Custom Flooring
    Gallery: Custom Flooring
  • Video: Build a curved step
    Video: Build a curved step
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
next
Pin It

Weaving Wood and Tile Into a Stunning Floor

A field of slate squares is captured by a dadoed grid of reclaimed pine.

For the entry to his own house, custom builder Sean Flynn combined a grid of reclaimed heart pine with 6-in. squares of slate. In this Master Carpenter article, he describes the steps he took to make this beautiful woven entry. He started by laying out a grid on the subfloor with the help of a story pole, which not only helped with accuracy on the subfloor but also allowed him to mark the dadoes on the stock in the exact same position. He used different colors of chalk for the respective vertical and horizontal lines, then sprayed them with polyurethane so they wouldn't smudge. After registering the lines onto the boards, he cut the dadoes with a dado stack on a tablesaw, alternating the half-laps facing up with those facing down. To begin the weave, he joined two boards in a corner, then continued by running all the horizontal boards from the first vertical. For each joint, he glued the dado facing up, using hammer blows and clamps to ensure a tight fit. Construction adhesive, pocket screws, and surface-mounted screws on perimeter ends connected the grid to the subfloor. Flynn then added a frame built with pocket screws. With the entire grid in place, he adhered each slate tile to a piece of decoupling membrane and filled in the gaps with a sanded acrylic caulk. With the application of several coats of Waterlox, the job was finished.

Weaving Wood and Tile Into a Stunning Floor

Become a Fine Homebuilding Member

to view this article and over a thousand more

Learn More