Variable outfeed pipe support - Fine Homebuilding Tip
  • Install a Vinyl Privacy Fence
    Install a Vinyl Privacy Fence
  • Magazine Departments
    Magazine Departments
  • Video Series: Tile a Bathroom
    Video Series: Tile a Bathroom
  • Remodeling Articles
    Remodeling Articles
  • Master Carpenter Videos
    Master Carpenter Videos
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • 9 Concrete Countertop Ideas
    9 Concrete Countertop Ideas
  • Design Inspiration
    Design Inspiration
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • Energy-Smart Details
    Energy-Smart Details
  • All about Roofing
    All about Roofing
  • Deck Design & Construction
    Deck Design & Construction
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Basement Remodeling Tips
    Basement Remodeling Tips
Pin It

Variable outfeed pipe support

I had to cut some PVC pipe to length with a chopsaw, and I needed to support the far end of the pipe at a height equal to the saw’s table. I could have cobbled together a stack of wooden blocks, but I wanted to do something a little less crude.

As shown in the drawing below, I clamped together a couple of Speed Squares to form a V that cradles the end of the pipe. Sliding one square against the other gave a precise height adjustment, and the clamp bar provided a support to keep the V in position.

Next Article
Next Article: Tip: