previous
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Video: Build a curved step
    Video: Build a curved step
  • 12 Remodeling Secrets
    12 Remodeling Secrets
  • Buyer's Guide to Insulation
    Buyer's Guide to Insulation
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Play the Inspector Game!
    Play the Inspector Game!
  • The Passive House Build
    The Passive House Build
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Remodeling in Action
    Remodeling in Action
  • How to Install Housewrap Solo
    How to Install Housewrap Solo
  • All about Roofing
    All about Roofing
  • The Hobbit House and More
    The Hobbit House and More
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Electrical Articles & Videos
    Electrical Articles & Videos
  • Deck Design & Construction
    Deck Design & Construction
  • Energy-Smart Details
    Energy-Smart Details
  • Shorten a Prehung Door
    Shorten a Prehung Door
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • Master Carpenter Videos
    Master Carpenter Videos
  • Magazine Departments
    Magazine Departments
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
next
Pin It

VIDEO: How To Air-Seal and Trim an Insert Replacement Window

Your window installation isn't done until you've caulked outside and installed stops inside

caulk-insert-window.jpg

Remodeler, Mike Sloggatt: I like to use foam on all my installations to make sure there’s a good air seal. Just make sure you use a good window and door foam. Put foam along the entire opening, starting at the bottom. Get a good bead. While the foam sets up on the interior, run backer rod around the outside gap of the window to seal it properly before putting on the exterior trim. Even though it will be covered with trim, I tool it a little bit to get a good seal.

This window system comes with an exterior stop cover—a lot more convenient than having to bend up coil and figure out how to cover that space. I need to cut the stop cover at 35 and ¾.

Narrator: Once Mike has installed the stop cover, he runs another bead of sealant around the perimeter, closing the gap between the stop cover and the existing brick mold trim. The sealant is a solvent-based siding and trim caulk. It’s available in dozens of colors to match popular windows and doors. Mike trims the foam with a knife and scrapes away the excess. He uses a molding bar, although any scraping tool will work. Mike trims down the original window stops, removed earlier, to match the thickness of the new window. He dry-fits the stops, starting at the top; then he fits the sides, and finally he secures them with an 18-gauge brad nailer.

Mike Sloggatt:I’ve reapplied the old stops to match the original casing. That wraps up this window. We’re done.




Become a Fine Homebuilding Member

to view this video

Learn More