previous
  • Video: Install a Fence
    Video: Install a Fence
  • Magazine Departments
    Magazine Departments
  • Video Series: Install a Rock-Solid Tile Floor
    Video Series: Install a Rock-Solid Tile Floor
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • Remodeling in Action
    Remodeling in Action
  • Video: Build a curved step
    Video: Build a curved step
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Deck Design & Construction
    Deck Design & Construction
  • Master Carpenter Videos
    Master Carpenter Videos
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
  • Gallery: Custom Flooring
    Gallery: Custom Flooring
  • Solid Deck-Framing Advice
    Solid Deck-Framing Advice
  • 12 Remodeling Secrets
    12 Remodeling Secrets
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Energy-Smart Details
    Energy-Smart Details
  • All about Roofing
    All about Roofing
next
Pin It
LS1016L Sliding Compound Miter Saw

Makita - LS1016L Sliding Compound Miter Saw

This 10-in. sliding miter saw from Makita features a four-rail-slide providing extra cutting capacity for its size.

$550.00 (As of 8/14/2009)

> (1 user review) Write a Review

View all photos
User Reviews
8/13/2010

Excellent: The first project with this saw was an octagon leg mantle...this type of mantle has lots of off angle cuts on base, crown backer, crown, small trim pieces...The laser was dead on so that sneaking up on lines wasn't needed....Of course, as with all my saws, the Forrest Chopmaster blade makes for near perfect fits on all cuts...I also use this saw now, instead of my 25+ year old Rockwell Sawbuck, for stair treads...the laser and electronic motor control makes it the perfect saw for treads with no bogging down...The Sawbuck is in retirement at last....I did have to cut the elbow from a floor attachment to connect to my Fein 1 1/4" vacuum hose and the angle of this works well with my shop setup....I have read about the bearings grinding or sticking, but with this saw, none of that has happened....A higher fence would have been nice, but I do have a 12" saw if I get into needing to cut a lot of 5 1/4" base standing up right..very impressed with this saw....