Framing Basics: 3 Tips for Laying Out Wall Plates
Pro framers Larry Haun and Scott Grice share their top layout tips for wall framing.
1. Mark the corners and wall intersections first
Use a corner marker (which may be a tool you’ve never seen before) or square to mark the locations where the butt walls hit the through walls. This is where the stud layout starts. To use a square, follow the plates up, square it across, and square it down. Lay the corner marker on the corner, and mark both edges and the outside. You can make a corner marker with either a piece of 2×6 or 2×4. Allow 3 in. (the thickness of the plates) to hang over one side of a T, and nail the two pieces of wood together. It’s important that all interior walls have marks because this shows where the butt or interior wall goes.
2. Use double top plates to guide the second-floor layout
A double top plate has to span any break in the plates below by 4 ft. minimum on each side. Applying the double top plate first allows you to run the joist layout done while the walls are on the ground. This way, you’re not running the joist layout on a ladder. Or you can just double-top-plate the walls that have joists on them. Walls without joists don’t need to be double-top-plated; this can be done during framing.
3. Use the right tools to mark the layout quickly and accurately
Detail or lay out all studs, windows, doors, etc. You can use either a 50-ft. tape or a layout stick. Using the layout stick, place the edge half on the end of the wall plates. Mark both sides of the layout stick every 2 ft. The mark on the double top plate is where the joist will sit, and the mark on the top plate is where the stud will fall. Lay out every stud in every wall, but keep in mind that simplicity and clarity are the key. Too many marks, and the framers can’t follow your work.