• Radiant Heat Comparison
    Radiant Heat Comparison
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Video Series: Tile a Bathroom
    Video Series: Tile a Bathroom
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Magazine Departments
    Magazine Departments
  • Energy-Smart Details
    Energy-Smart Details
  • Remodeling Articles
    Remodeling Articles
  • Find the Pitch of a Roof
    Find the Pitch of a Roof
  • Ultimate Deck Build 2015
    Ultimate Deck Build 2015
  • Master Carpenter Videos
    Master Carpenter Videos
  • Deck Design & Construction
    Deck Design & Construction
  • Design Inspiration
    Design Inspiration
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Video: Install a Fence
    Video: Install a Fence
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • All about Roofing
    All about Roofing
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
Pin It

Siding a house solo with adjustable hooks

I recently had to side a house by myself. I wanted the courses of lap siding to line up neatly with the windows, requiring slightly different exposures for boards below, between, and above the windows. The courses were easy enough to lay out on a story pole, but without a helper, I needed some way of holding the pieces of siding in place while I lined them up and nailed them off. None of the siding gadgets I could find locally was adjustable for different exposures, and I couldn’t wait for mail order. The drawings illustrate my solution.

I cut a piece of thin multipurpose metal strap in two and bent a hook in the end of each piece. Then I drilled 1/4-in.-dia. holes in a pair of 2-in. wooden drawer knobs, as offset from center as the back of the knob would allow. I then drilled a 1/4-in. hole in each piece of strap at the approximate height to get the exposure I wanted. With a couple of sawcuts in each strap, the holes became horizontal slots. I attached the knobs to the straps with machine bolts and wing nuts, and was ready to go to work.

To use the gadgets, I hung them from the top of a nailed-off course of siding, far enough apart to support the next piece of siding. I then rotated the knob (now an eccentric cam) back and forth until the bottom of the board lined up with the appropriate mark on my story stick. I drove a few nails to hold the board in place, loosened the wing nuts so that I could slide the knobs sideways and off the straps, and pushed up the straps to release the hooks. Because there were only a few nails in the top board, I could flex it enough to pull the straps free. I then reattached the knobs, hooked the gadgets over the board I’d just attached, and nailed off that board. Then I was ready for the next course.

Installing fiber-cement lap siding with a clean top edge, I found that this method worked perfectly. And because the offset holes in the knobs allow for about a 3/4-in. range of adjustment, these gadgets also should work for wood lap siding, even when the top edge isn’t as precise. Total time to make the device was less than a half hour, and total cost was less than $5.


Photo by: Charles Miller

Next Article
Next Article: Tip: