Replacing a door jamb - Fine Homebuilding

previous
  • Clever daily tip in your inbox
    Clever daily tip in your inbox
  • 9 Concrete Countertops Ideas
    9 Concrete Countertops Ideas
  • Read FHB on Your iPad
    Read FHB on Your iPad
  • Custom Flooring Inspiration
    Custom Flooring Inspiration
  • All about Roofing
    All about Roofing
  • Master Carpenter Videos
    Master Carpenter Videos
  • 7 Smart Kitchen Solutions
    7 Smart Kitchen Solutions
  • Video: Install a Fence
    Video: Install a Fence
  • Basement Remodeling Tips
    Basement Remodeling Tips
  • Video Series: Tile a Bathroom
    Video Series: Tile a Bathroom
  • Magazine Departments
    Magazine Departments
  • 7 Trim Carpentry Secrets
    7 Trim Carpentry Secrets
  • Remodeling Articles
    Remodeling Articles
  • Energy-Smart Details
    Energy-Smart Details
  • 7 Small Bathroom Layouts
    7 Small Bathroom Layouts
  • Tips & Techniques for Painting
    Tips & Techniques for Painting
  • Radiant Heat Comparison
    Radiant Heat Comparison
  • Design Inspiration
    Design Inspiration
next


Replacing a door jamb

comments (1) January 31st, 2011 in Project Gallery
Click the thumbs up button above to vote for this tip. Help us choose Fine Homebuildings top-10 window and door tips. Click To Enlarge

Click the "thumbs up" button above to vote for this tip. Help us choose Fine Homebuilding's top-10 window and door tips

Photo: Drawing by Chuck Miller

Occasionally I'm hired to replace door jambs that have been damaged by burglars. Often, only one jamb leg is damaged (the strike side of the door). The other side jamb and head jamb remain serviceable, so replacing the strike jamb without messing up the rest of the installation is the problem. Here's how I do it.

I begin by adding some extra finish nails to the door casings on the good leg and the top jamb. This step helps to hold everything in place. Then I pull the casings from the damaged jamb. Drawing 1 shows the point at which I drill a 1/4-in. or 5/16-in. hole in the side jamb next to the head jamb. This hole lops off the top of the damaged jamb. To remove the jamb, I cut it in half at about the height of the strike plate and pry away the two pieces.

Drawing 2 shows the jamb being removed and the fragment of the jamb top lying on the head jamb. If there's room I pull this scrap out. If not, there's usually room to shove it out of the way up top. If I can reach them, I pull the nails out of the head jamb with needlenose pliers. If I can't, I use a reciprocating saw to nip them off.

Drawing 3 shows the new jamb in place. Note how I've cut off the end of the new jamb, giving it a rabbet instead of a dado. This allows the new jamb to be tucked into place if the clearance between the rough framing and the head jamb is tight. If there's room I leave the dado in place. In either case, I toenail the new side jamb to the head jamb and back the joint with shims to keep it tight. Now the new jamb can be plumbed with shims or adjusted to match existing conditions.

 

Chris Dahle, Denver, CO 

From Fine Homebuilding 75, pp. 2

 


posted in: Project Gallery, doors

Comments (1)

longlivelavey longlivelavey writes: Seems simple enough. Gonna try this on my front door's damaged jamb.
Posted: 12:17 am on November 18th

Log in or create a free account to post a comment.