*
metal roof came was deliever today, no instruction. Every thing going good so far. I have 70 % up already. QUESTION: there is a change in pitch from 5/12 to 2.5/12. They gave me a panel that will bend this joint. It goes on top the bottom panel and below the upper panel. But I cannot figure how. Its a smooth five foot piece bent in a “V” with a sharp lip about a inch down bent opposite the “V” only on one end. How does it go.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Learn how to fight wood-boring beetles and prevent home infestations with expert advice from Richard D. Kramer, an authority in pest control.
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
*
metal roof came was deliever today, no instruction. Every thing going good so far. I have 70 % up already. QUESTION: there is a change in pitch from 5/12 to 2.5/12. They gave me a panel that will bend this joint. It goes on top the bottom panel and below the upper panel. But I cannot figure how. Its a smooth five foot piece bent in a "V" with a sharp lip about a inch down bent opposite the "V" only on one end. How does it go.