*
Anyone have a source for 36×66 shower base? www.marbletrend.com.au has one but they’re in Australia. A low sill height (13″) tub would be OK. Cast iron preferred. Acrylic second.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Listeners write in about power tool batteries, replacing sheathing behind brick, and rebuilding a pressure-treated deck.
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
*
Hi Rick,
Try calling Accent Manufacturing at 330-724-7704. They are in Akron, Ohio and can make a shower base any size. Shipping cost may or may not be a problem, but I'm sure they could refer you to someone closer to you if it is. They do nice work-I've used them on many custom jobs. Tell them John Svenson refered you. I don't have an e-mail for them so you'll have to use the old phone. Hope this helps. John
*
Rick:
Try American Shower and Bath. They have a web site. I just got a replacement shower base for a unit that I bought over three years ago and just got around to starting the install.
They were straight up with me and honored a warranty on a unit that was manufactured by a company they bought out two years ago. Their former name was Plastico. I am almost positive they have a 36 x 66 base. It will be reinforced structural fiberglas. They may have other lines which include iron or acrylic.
Dave Matheny
*
Anyone have a source for 36x66 shower base? http://www.marbletrend.com.au has one but they're in Australia. A low sill height (13") tub would be OK. Cast iron preferred. Acrylic second.