*
Anyone try the new 23 gauge pinner from Acuset? Wondering if it would be good for crown molding and other finish trim around cabinets?
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
In this episode, listeners discuss outdoor lighting, air-barrier improvements, DIY insulation, and more.
Featured Video
SawStop's Portable Tablesaw is Bigger and Better Than BeforeHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
*
I recentley started using that pin nailer. I use it mainly for 1/4" thick stock that's also attached with glue. It leaves a very small nail hole, but without a head there's not much holding power. A client I had just installed some cabinets for was so impressed with the gun he said he was going out to buy one, his use though was for his hobby of carving ducks. He thought it would be great for attaching some of the 'hard to clamp' parts when glueing.
*
Anyone try the new 23 gauge pinner from Acuset? Wondering if it would be good for crown molding and other finish trim around cabinets?