I have gable returns that just fit against the vinyl about 1″in thick x almost a 10″in rn x a few inches rs.i want to use aluminum. there are no barge rafters on this home. does anyone know what tool is needed. can it be done with a 10-6 brake and also are these small bends difficult to make. does anyone have any tips. if i need a hand tool to do this,what is it and where can i purchase one.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Learn how to fight wood-boring beetles and prevent home infestations with expert advice from Richard D. Kramer, an authority in pest control.
Featured Video
SawStop's Portable Tablesaw is Bigger and Better Than BeforeHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.