I’m new to this forum, but my scavenging habit goes back a ways. Recently I’ve come across a source of old brick (abandoned factories), and I’m wondering if I can use them to pave a driveway. They’re just the bricks used in the walls, now falling down as the mortar deteriorates. Assuming I can accumulate enough of them, will they hold up to cars and Maine winters?
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Michael Hindle explores the efficacy of deep energy retrofits and discusses essential considerations for effective climate mitigation.
Featured Video
Builder’s Advocate: An Interview With ViewrailHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
Most likely these bricks will be too soft. They will absorb water and freezing will break them up if used for paving. You need a hard fired brick for paving. Try soaking one in water for a few hours and pop it in your freezer and see what happens to it.
If you can get them the bricks that were used pave streets are the best for what you want to do.
It beats mud but in the long run, you will be disappointed with all that work and the results you end up with
Welcome to the
Taunton University of Knowledge FHB Campus at Breaktime.
where ...
Excellence is its own reward!
save the darker colored ones and leave the lighter, salmon colored ones.
The WILL explode!!!! Been there, done that!
BTW...if you stack em on a pallet a mason yard pays good money for used brick...around here "Nassau" brick gets me about 30 cents each..
If Blodgett says, Tipi tipi tipi it must be so!
TipiFest 06~~> Send me your email addy for a Paypal invoice to the greatest show on earth~~>[email protected]