In cold weather, two-part epoxy in a double syringe-style dispenser can be difficult to squeeze out. If it’s a little sluggish, spare yourself the fight, and put the dispenser in a caulk gun. The dispenser fits right where the caulk tube normally goes and stays in place once you have the plunger against the push pins.
—Kevin Ireton, New Milford, CT
Edited by Charles Miller
From Fine Homebuilding #258
Fine Homebuilding Recommended Products
Fine Homebuilding receives a commission for items purchased through links on this site, including Amazon Associates and other affiliate advertising programs.
Handy Heat Gun
This heat gun is great for drying joint compound, primer and paint when patching drywall and plaster walls. Plus it can soften adhesive, get a very cold small engine to start, and shrink heat-shrink tubing.
Affordable IR Camera
This camera is super useful for tracking down air leaks in buildings. The one-hand pistol grip arrangement frees your other hand for steadying yourself while maneuvering tricky job sites.
8067 All-Weather Flashing Tape
Available in 2- to 12-in. widths, this is a good general-purpose flashing tape that sticks well to most things. It features a two-piece release paper, water-shedding layers, and good UV resistance.
View Comments
Better still, store the epoxy in a warmer location. Further, some epoxies have limitations as to what temperature they should be used at.
was using some boat builder's cold weather epoxy last winter on a renovation project. What they do not tell you...the epoxies that actually cure in freezing weather, are chock full of nasty volatile compounds! Luckily i had a carbon filter for my respirator handy, or i would have lost my liver on that job!
There are always small areas you can electric space heat to store epoxies. But the problem is, where they are applied and cure are not always heated.