Hi looking for information on running diminished stiles(aka gunstock stiles) for french doors,on a spindle?templates? copy plates? Currently i make them cope and stick, with lots of setting out, handtools and sweating that final fit. Would love references or any ideas. Pete
With the right approach, you can restore old hardware—whether through soaking, scrubbing, or polishing—giving it a fresh look while preserving its original charm.
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Dig into cutting-edge approaches and decades of proven solutions with total access to our experts and tradespeople.
Start Free Trial NowGet instant access to the latest developments in green building, research, and reports from the field.
Start Free Trial Now
Replies
Greetings pete-
This post, in response to your question, will bump the thread through the 'recent discussion' listing again which will increase it's viewing.
Perhaps it will catch someone's attention that can help you with advice.
Cheers
Parolee # 53804
I think ya bumped a bump, it was answered by me.Parolee # 40835
Multiple listing, aye?
Happens. My bad but hey, hard to track.
be railroaded
Parolee # 53804
Ayeah. I told him to saddle jig the tennons and to rout the stiles while in the 4square, then taper rip the stiles..I hope he followed the advice.Parolee # 40835
Were you able to locate the info you needed?
Parolee # 53804