O-Ring for Paslode Impulse Finish Nailer
I have one of the original Paslode Implulse (black gun,round batttery) finish nailer.I have had no problems with the gun until lately.After you fire the gun the driver does’nt retract.I noticed the O-ring is worn.I brought it to my lumber yard and they told me that O-ring is not available.If anyone has any info on this part I would greatly appreciate it.I just spent $50 on a new battery and hate to get A new one for the sake of an round piece of rubber.
Replies
Start a a good hardware store or autoparts store and get out the O-ring replacement kit and see if they have a match.
.
A-holes. Hey every group has to have one. And I have been elected to be the one. I should make that my tagline.
check out this link:
http://www.paslode-cordless.com
click on customer support (top right) click once to enable, click again to go to site.....once there
click either "maintenance kits" or "where to buy/service"
Geoff
Coastal tool has been servicing these for a long time and should have parts.
Keep looking - I cannot tel you how many times guys in hardware stores and lumberyards have lied to me and said that something is not available when the truth was simply that it was going to be difficult or expensive for them to procure it, or they were simply ignorant of how to get what I needed.
Welcome to the
Taunton University of Knowledge FHB Campus at Breaktime.
where ...
Excellence is its own reward!
I have also used the 800 number on the book that comes with the guns to call and order direct from the company in the past
Welcome to the
Taunton University of Knowledge FHB Campus at Breaktime.
where ...
Excellence is its own reward!