What do you prefer in a framing nailer. The job I am on now, framing a garage,using a Makita. You have to be very careful how you handle the nails in this hot weather, because they slip a little out of place and jam in the gun,especially the 8’s,and jam. Not to mention the plastic hitting you in the face. I would use my old Paselode SK312 but there are no nails for it on the job. Now that Paselode makes a full head nail,offset as it may be, it still is accepted as a full head nail.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Learn more about the benefits and compliance details for the DOE's new water heater energy-efficiency standards.
Featured Video
How to Install Exterior Window TrimHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
Greetings Jerry,
This post, in response to your question, will bump the thread through the 'recent discussion' listing again which will increase it's viewing.
Perhaps it will catch someone's attention that can help you with advice.
Cheers
Hitachi coil nailer, don't like to have to reload all the time!
wire collated...
less wasted nails...
less flying bits of plastic...
most weather proof...
more green....
less mess to clean up..
cheaper than plastic...
paper second choice....
prefer not to use plastic...
Life is not a journey to the grave with the intention of arriving safely in a pretty and well preserved body, but rather to skid in broadside, thoroughly used up, totally worn out, and loudly proclaiming
WOW!!! What a Ride!
Forget the primal scream, just ROAR!!!
I hate the plastic in the face.
Some body's sick joke.
don't think the OP wants to talk to us....
Life is not a journey to the grave with the intention of arriving safely in a pretty and well preserved body, but rather to skid in broadside, thoroughly used up, totally worn out, and loudly proclaiming<!----><!----><!---->
WOW!!! What a Ride!Forget the primal scream, just ROAR!!!