Anyone have a quick trick to get the length right on the flip stopper on the bathtub. It always takes forever to get the cylinder the right length to stop the bathtub water. Is it supposed to sit where the the tub drain’s horizontal meets the waste and overflow’s vertical, or can it go lower?
I always hate messing with it, and was hoping one of you guys new a quick way to do it?
Replies
Greetings Cooper,
This post, in response to your question, will bump the thread through the 'recent discussion' listing again which will increase it's viewing.
Perhaps it will catch someone's attention that can help you with advice.
Cheers
Click here for access to the Woodshed Tavern
Click here to visit the beginning of Breaktime
if you have the install guide that came with the tub it will tell you.
Dunno, always taken me eleventy tries to get it to right.