I have a Delta Unisaw that was given to me. The top is covered in rust, how do I go about removing this and preventing it in the future? Any products to use would be greatly appreciated. Thanks
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Fine Homebuilding is excited to be the official media partner of the 2024 Building Science Symposium series! This event offers builders, tradesmen, architects, designers and suppliers to discuss topics ranging…
Featured Video
SawStop's Portable Tablesaw is Bigger and Better Than BeforeHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
Sand it down and wax it with johnsons paste wax.
Try not to post the same thing in two places for starters. (:-)
Gee, there's another guy here with exactly the same problem! Find his thread and read away
Welcome to the
Taunton University of Knowledge FHB Campus at Breaktime.
where ...
Excellence is its own reward!
Da*n you are good.
Hey,
he's a novice.
be owwwwch
'Nemo me impune lacesset'No one will provoke me with impunity
Yeah, but he's a good enough guy that somebody would give him a tableesaw.So that means he has a sense of humour
Welcome to the Taunton University of Knowledge FHB Campus at Breaktime. where ... Excellence is its own reward!
who? mikethenovice?:o)
be with no vice or two beers to the wind
'Nemo me impune lacesset'No one will provoke me with impunity
I do have a sense of humor and I'm sorry for posting in more that one spot. I like the navel butter and jelly thing, that's pretty good. Thanks to everyone for the suggestions. Have a nice weekend.
Naval peanut butter.
"Citius, Altius, Fortius"
With a naval coffee chaser.