*
I’m looking for information on the appropriate tablesaw for the business I’m am presently in the the process of establishing – a renovation and woodworking business. The work will include everything from minor home repairs to basement/bath renovations, decks,etc. Cabinet work will also be a part of it; however, not extensively (a couple of kitchens a year, utility cabinets for garages, etc ). I use the Delta Unisaw at work; however, I would like some feedback on two other models I’ve been considering.
1) General 350. Made here in Canada.
2) Dewalt 746. I realize this is not in the same caliber as the cabinet saws; however, I would greatly appreciate some feedback on it’s performance and capabilities.
Thank you very much
Mike Scidmore
Moose Jaw, Saskatchewan, Canada
Replies
*
gold buttons above....click on
b Search
....enter
i ...table saw....
Also look in folder above
b ...Tools For Homebuilding...
near the stream,
aj
*You want to REALLY get a lot of opinions, check the archives at Knots (Fine Woodworking forum). Tablesaw choice is probably the number one topic over there.
*Mike,Sounds to me like your gonna need 2 tablesaws; the cabinet style that will always remain in your shop (since your'e wanting info on supposedly cabinet types) and a smaller, contractor style that you can lug with you to the jobsite for the occaisional ripping and trim stuff.I don't own or have operated either the General or the DeWalt you are asking about. I have seen the DeWalt, and thought it to be more gimmicky (all show, but no go.)If you want a really good, heavy cabinet saw, check out the Powermatic 66. This is what I own and use. The fence system is a Bieseymer and it is 100% true. The Systematic blade that came with the saw left virtually no chip out on the top and bottom cuts. Hardwoods, softwoods, and plwoods all remain chip free after being cut. This saw is expensive. Expect to pay $2200 for it with the long extension table and rolling stand. This saw is very heavy (over 600 lbs. I think)and not practical for moving from job to job.A Delta Contractor's saw is light enough to move and will work fine at jobsites. DeWalt also makes a lightweight (plastic) contractor saw that, though is small in size, seems to be well designed and with a nice size stand, may also work quite well.I'm not saying to buy these; just give it some thought before purchasing.Davo.
*
I'm looking for information on the appropriate tablesaw for the business I'm am presently in the the process of establishing - a renovation and woodworking business. The work will include everything from minor home repairs to basement/bath renovations, decks,etc. Cabinet work will also be a part of it; however, not extensively (a couple of kitchens a year, utility cabinets for garages, etc ). I use the Delta Unisaw at work; however, I would like some feedback on two other models I've been considering.
1) General 350. Made here in Canada.
2) Dewalt 746. I realize this is not in the same caliber as the cabinet saws; however, I would greatly appreciate some feedback on it's performance and capabilities.
Thank you very much
Mike Scidmore
Moose Jaw, Saskatchewan, Canada