Somebody around here is selling a tapco pro2000 in the paper. He said that the spring need to be replaced because it doesn’t stay open anymore. I looked on tapcos site but I don’t see any springs. Is there an adjustment to be made on them for this?
He also said there is a rebuild kit for them but I don’t see it. What is involved in rebuilding one of these? any info before I go look tomorrow will help.
Headstrong, I’ll take on anyone!
Edited 8/20/2006 9:28 pm ET by Jemcon
Replies
http://www.tapcotools.com/PDFS/Parts-PROBrake.pdf
I think you are looking for the pivot spring clip
I wrote it wrong. its a pro 2000.
Headstrong, I'll take on anyone!
I don't see the 2000 on their website, but I think the spring system is pretty similiar. call your local distributor tomoorow, yhey should have the parts
Edited 8/20/2006 9:44 pm by BarryE
The 2000 is under discontinued equipment. I don't see spring on that one.
Headstrong, I'll take on anyone!
hmm, I see it now. I had the Pro III and it had a spring on it.I wonder if the locking handle pins have worn and need replaced?sorry, I can't help on that one
Barry E-Remodeler