I have recently begun framing by putting the wall sheathing on before raising it. This is new for me, and I have been experiencing some problems keeping the sections square. I would appreciate any tips anyone may have to simplify this process. Thanks ! Bill
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Fine Homebuilding is excited to be the official media partner of the 2024 Building Science Symposium series! This event offers builders, tradesmen, architects, designers and suppliers to discuss topics ranging…
Featured Video
How to Install Cable Rail Around Wood-Post CornersHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
I don't use that method, however...assuming the platform is properly built...and the studs and plates are properly sized so the wall section can be made square:
I've seen the wall squared (measured diagonals) while flat on the platform, then a diagonal 2-by was nailed off to keep it from racking. Sheathing applied, and the angled 2-by was pulled when sheathing that portion.
Other method that I've seen used and which seemed better was to toenail the sole plate to the platform where it will be raised (if space allows), then build the wall off that sole plate. After built, then square the wall and toenail the other sides to the platform...just enough to secure it...then sheath. Pull the toenails except for the soleplate, use those to "hinge" the wall up. Seemed to work pretty well.
Hmmmmmmm, same question, same poster, different disscussion.
no turn left unstoned