I have a Delta 37-070 bench top jointer with variable speed control. The speed control has failed twice in two years. I would like to bypass it and run at full speed, but connecting the wires at the speed control panel doesn’t seem to work. Can anyone offer suggestion regarding how to direct wire the motor?
If direct wiring is not possible, does anyone know where I can just buy a speed control card without hauling the whole unit into a tool repair shop?
Thanks in advance for any help.
Replies
Greetings dlow, as a first time poster Welcome to Breaktime.
This post, in response to your question, will bump the thread through the 'recent discussion' listing again.
Perhaps it will catch someones attention that can help you with advice.
Cheers
'Nemo me impune lacesset'
No one will provoke me with impunity
Edited 1/25/2006 1:33 pm ET by razzman