How to Remove and Replace a Section of Vinyl Siding
All it takes is a few minutes and a few simple tools to get access for repairs or modifications to a wall covered in this popular cladding. Watch this Building skills video to see the entire process.
Here are the basic steps:
- Look for a horizontal seam between two courses of vinyl siding
- Insert the siding-removal tool where the panles overlap and pull down and out
- Use a cat’s paw or other small pry bar to pull the nails from the course you need to remove
- Pull the piece of vinyl siding downward to disengage it from the course below it
- If either end of the siding is captured by a door or window channel, gently bend the siding to clear the channel as you remove it
- Repeat steps 3-5 for any additional courses of siding that you need to remove
When it’s time to put the siding back on the wall, just reverse the process: slide and snap the pieces of siding onto the courses below and replace the nails you removed. You may want to drive the nails in new locations to ensure they have good purchase. It can be a little tricky to snap the last piece into the groove of the piece above that wasn’t removed, but a little care, patience, and perseverence will get the job done.
For more information, read the companion Bulding Skills article: Removing Vinyl Siding